[AMRadio] Tube bake in process.


Tom Elmore tom at telmore.com
Tue Oct 5 22:33:15 EDT 2004


It is an Eimac HK-24.

-----Original Message-----
From: amradio-bounces at mailman.qth.net
[mailto:amradio-bounces at mailman.qth.net]On Behalf Of Jim Wilhite
Sent: Tuesday, October 05, 2004 5:48 PM
To: Discussion of AM Radio
Subject: Re: [AMRadio] Tube bake in process.


Run the filaments for a minimum of half hour before applying high 
voltage.  You don't mention what tube you are speaking about, but if 
it is an Eimac, go to their website and read their technical 
information.  http://www.cpii.com/eimac/index.html

The information is good no matter who made the tube(s).

73  Jim
de W5JO

----- Original Message ----- 
From: "Tom Elmore" <tom at telmore.com>
To: <amradio at mailman.qth.net>
Sent: Tuesday, October 05, 2004 6:58 PM
Subject: [AMRadio] Tube bake in process.


>I just acquired some NOS RF tubes and  have been told I should bake 
>them in
> before using them . Is this true should I just run filament only 
> no high
> voltage for several hours. The tube in question is an HK-24 
> triode.
>
> Thank You
> Tom Elmore
> Anchorage  Alaska
>
> ______________________________________________________________
> AMRadio mailing list
> Home: http://mailman.qth.net/mailman/listinfo/amradio
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:AMRadio at mailman.qth.net
>
> 


______________________________________________________________
AMRadio mailing list
Home: http://mailman.qth.net/mailman/listinfo/amradio
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:AMRadio at mailman.qth.net




More information about the AMRadio mailing list

This page last updated 17 Oct 2017.