[AMRadio] Home Brew


Crawfish crawfish at surfmore.net
Mon Oct 18 18:45:57 EDT 2004


I know this is an older post, but in the event anyone wants to do this, I
have the article from 10th edition(1946) West Coast handbook with this
circuit in it.

Joe W4AAB
----- Original Message -----
From: John Coleman <wa5bxo at pctechref.com>
To: 'Discussion of AM Radio' <amradio at mailman.qth.net>
Sent: Tuesday, September 28, 2004 6:08 PM
Subject: RE: [AMRadio] Home Brew


If I were going to build with tubes again and two hundred watts was
the carrier output that I wanted.  I would use a pair of 812s in push pull
class C and modulate with a pair of 811As push pull class B.  Run about 1500
volts @ 200 ma for 300 watts plate input on the 812s.  Find a Modulation
XFMR to match the output of 811A class B (about 12500 ohms as I remember) to
the 7500 ohm class C final.

John, WA5BXO

-----Original Message-----
From: amradio-bounces at mailman.qth.net
[mailto:amradio-bounces at mailman.qth.net] On Behalf Of StephenTetorka at cs.com
Sent: Tuesday, September 28, 2004 2:50 PM
To: amradio at mailman.qth.net
Subject: [AMRadio] Home Brew

Hello All:

I'd like to build my own AM transmitter.
Tube style; more than 200 watts.

Sure a heck of a lot to choose from...but I'd like to hear what you think.


OR...if someone knows of a home brew for sale....

Tnx,
Steve




______________________________________________________________
AMRadio mailing list
Home: http://mailman.qth.net/mailman/listinfo/amradio
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:AMRadio at mailman.qth.net






More information about the AMRadio mailing list

This page last updated 18 Oct 2017.