|[AMRadio] AM Amps|
garyschafer at comcast.net
Tue Jan 11 22:32:18 EST 2005
First you would need to tune it up at the 1500 watt out level. Then
apply enough drive from the ranger so you have about 375 watts carrier
out. That will be good for 100% modulation peaks. If you want to run
more than 100% modulation then you would need to lower the carrier level
with less drive.
Byron Lichtenwalner wrote:
> If you had an amp rated at 1500 pep rated for Continuous Commercial
> Service and were going to drive it with a Ranger, (with W3AM's
> modification as an example) where would you set the carrier level with
> no modulation?
> Byron, W3WKR
> AMRadio mailing list
> Home: http://mailman.qth.net/mailman/listinfo/amradio
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:AMRadio at mailman.qth.net
More information about the AMRadio mailing list
This page last updated 10 Dec 2017.