[AMRadio] FS: Parts EFJ, Millen, Bud, RCA, UTC, Thordarson, More


Merz Donald S merz.ds at mellon.com
Mon Nov 28 10:12:25 EST 2005


For Sale: Bad price? Make an offer. Looking for something else? Ask!

EF Johnson 150ED30 dual 152mmf variable cap, NOSB. $15
EF Johnson  153-510 dual 100 uuf 7,000V variable cap, NOSB. $25

Millen Parts, $30 for all. All NOSB unless noted.
	Five 74001 RX coils, NOS, no box 
	Eight 34280 80 uh RF Choke
	Two 34926-choke in bakelite case

Bud Coils: $10 all 4
	Five-pin: 15JEL, 20JEL
	Six Pin: 10E, 20E

1625 Tubes: 2 NOSB, 8 pulls that look unused. $17/all

Two RCA 807 tubes, one NOSB and one tested like new. $10/pair

Two RCA UR-542A ceramic tibe sockets for 4-pin triodes like 852, 100TH, etc. Used. $8/pair

Two EF Johnson ceramic sockets for old 4-pin triodes-identical to RCA sockets above. Used. $8/pair

Two EF Johnson large ceramic tube sockets. These are for your 250TH, 810 and similar tubes. Used. $8/pair

Four EF Johnson 122-227-1 7-pin ceramic tube sockets, NOSB. $15/all

Kenyon T-473 output transformer, NOSB. The tag says "Cath-O-Drive PP 6L6's AB or AB2 to Variable Load, Max Sec D.C. -450ma."  $25

Bud OCS-1. Tag says  "10 to 160 Meter Oscillator and Buffer Band Switch Assembly". This switches in various combinations of 3 coils. With label plate and sturdy ceramic switch. Proibably good for up to 20 watts or so. I have five of these. Three NOSB $14 each and two without box, needing a clean-up--$7 each.

UTC VM-5 300W Modulation transformer. Looks unused, but dirty. $125

Thordarson CHT Transformer type T-15S90 15 watt high-quality universal output transformer. Used, but in nice shape. $35

Thordarson CHT Transformer type T-15A74 audio transformer. I believe this is a multi-impedance driver trnsformer. $15

Two UTC H-170 Filter reactors (NOSB) with 2 windings. In series, it is .18-.11 HY at up to 2.A. In parallel, .045 Hy to 3 Mhy at up to 5A.  $5 each. 

Stancor P-8380 Filament Transformer, NOSB. 10V @ 3A, 1500VRMS test. $7

Stancor P-6308 filament transformer, used, 6.3V at 10A CT. $5

Stancor P-6456 filament transformer 6.3V @ 6A CT, 2000V test. $7

Stancor P-6469 filament transformer 25.2V @ 1A., unused. $3

Thordarson TR-5 490 ohms CT to 150 ohms CT. 150mw. Used, in box. $2

Thordarson TR-79 transistor power supply transformer input 6VDC output 250V, 6W. NOSB with docs. $5

Thordarson TR-309 Unioversal Driver Transistor Transformer Turns Ratio 1:1 thru 10:1, 1 watt. NOSB with docs. $5

Todd Electric transformer 115V input, 9-36 volts out depending on strapping. 2A at any voltage, 4A at 9V or 18V. NOSB with clear strapping instructions on it.  $5

B&W 80BVL 4-pin coil with ceramic base. Good condition. Needs cleaned. $7

B&W 80TL Five-pin coil with ceramic base. Taps have been soldered along the top of the coil. But ignore these and this coil is in good shape. $7

B&W 80TVL four-pin coil with jackbar and swinging link assembly. Coil needs some attention due to deterioration. But it is easily made right. $10

Simpson Model 374 0-1000 microamperes DC meter in black bakelite case. Five ranges: 50, 100, 250, 500 & 1000. Uses binding posts for connections. Working perfectly. $10

Simpson Model 373 0-1000 milliamperes DC meter in black bakelite case. Nine ranges: 1, 5, 10, 25, 50, 100, 250, 500 & 1000. Uses binding posts for connections. Working perfectly. $10

Triplett Model 676 0-1000 microamperes DC meter in black bakelite case. Five ranges: 50, 100, 250, 500 & 1000. Uses pin jacks for connections. Working perfectly. $10

Homebrew "thing". I think this is a 160 meter exciter. It's in a 19 inch wide gray hammertone aluminum cabinet about 12 inches high and 12 inches deep. The chassis is also aluminum. The PS is solid state, well-filtered, and powered by a line isolation transfomer. The only tubes in it are 2 50L6's. An aluminum box inside, that I didn't open, is marked 1,800,865 HZ. There are two variable caps, an MA meter and several toggle and rotary switches on the front. The ex-command set antenna connector is also on the front. On the back is a 4-pin female cinch-jones socket-for what? No key or mic connector is obvious.  Ceramic feed-throughs and tube sockets. Nice construction practices. But what's it good for? $15 as-is.

Thanks for looking.
73, Don Merz, N3RHT
 
The information contained in this e-mail may be confidential and is intended solely for the use of the named addressee.
Access, copying or re-use of the e-mail or any information contained therein by any other person is not authorized.
If you are not the intended recipient please notify us immediately by returning the e-mail to the originator.(17b)



More information about the AMRadio mailing list

This page last updated 17 Oct 2017.