[AMRadio] Pi-Net vs Link Couple

Brett gazdzinski Brett.gazdzinski at mci.com
Fri Sep 23 15:12:48 EDT 2005

It can take a bit of playing around with plate coil turns, and link turns,
to get the
best power output and efficiency.

I see the BC610 DOES do triode link coupled output...bet it's a bit tricky
to neutralize, then you would have to set up each band coil?

I never had a BC610, was it a pain to neutralize on each band?


-----Original Message-----
From: amradio-bounces at mailman.qth.net
[mailto:amradio-bounces at mailman.qth.net] On Behalf Of Donald Chester
Sent: Thursday, September 22, 2005 10:34 PM
To: amradio at mailman.qth.net
Subject: Re: [AMRadio] Pi-Net vs Link Couple

>I wonder though Don, while I've got your .. uhm 'ear' (eyes?)  The link 
>could use a little tuning to take a bit more load in the final.  I've 
>modified  one of my 80m B&W HDVL plug-in coils and removed two turns on 
>each side (4 turns, total), to raise the plate current a bit, because the Q

>is a bit sharp in that circuit.  A breif excursion off-resonance, w/1.5kWDC

>on the plates, draws around 550mA.  At Resonance (with 125mA of grid drive)

>the thing dips to around 200mA.  That said, what value of series 
>capacitance would you suggest/recommend to tune the link?

In mine, I use a 4-turn link.  On 80m I have about a 1000 pf air variable 
directly in series with the link, and I think about 300 pf is actually 
meshed in for resonance.  On 160 I use a capacitive voltage divider formed 
by two fixed micas in series (about .002 each) with the 1000 pf variable 
bridged across one of them for fine tuning.  The load is placed across one 
of the caps.  I can get good coupling that way. When I tried a simple series

cap on 160, I could hit resonance, but could only get about 10% coupling.  
On 40 I use the series cap, but it is almost completely unmeshed to hit 
resonance.  I duplicated the setup for my other homebrew rig, and it works 

73, Don

AMRadio mailing list
Home: http://mailman.qth.net/mailman/listinfo/amradio
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:AMRadio at mailman.qth.net
AMfone Website: http://www.amfone.net
AM List Admin: Brian Sherrod/w5ami

More information about the AMRadio mailing list

This page last updated 22 Jan 2018.