[AMRadio] Pi-Net vs Link Couple


Brett gazdzinski Brett.gazdzinski at mci.com
Fri Sep 23 16:33:42 EDT 2005


Did it use plug in coils?
Did you adjust the neutralization with the coil, or some series cap
from the coil to the grid?

>From looking at the diagram (it came out very little) the link swings
between the actual plate coil and the neutralization coil, don't that upset
things?

Just curious...
Brett
N2DTS

-----Original Message-----
From: amradio-bounces at mailman.qth.net
[mailto:amradio-bounces at mailman.qth.net] On Behalf Of Donald Chester
Sent: Friday, September 23, 2005 4:28 PM
To: amradio at mailman.qth.net
Subject: RE: [AMRadio] Pi-Net vs Link Couple



>I see the BC610 DOES do triode link coupled output...bet it's a bit tricky
>to neutralize, then you would have to set up each band coil?
>
>I never had a BC610, was it a pain to neutralize on each band?


Just neutralise it properly for the highest frequency band you intend to 
operate.  The setting should hold for all the other bands.

Don K4KYV


______________________________________________________________
AMRadio mailing list
Home: http://mailman.qth.net/mailman/listinfo/amradio
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:AMRadio at mailman.qth.net
AMfone Website: http://www.amfone.net
AM List Admin: Brian Sherrod/w5ami




More information about the AMRadio mailing list

This page last updated 21 Oct 2017.