|[AMRadio] HR-10 problem|
abeck at xplornet.com
Fri Apr 14 10:35:26 EDT 2006
good ideas, thanks.
Brett gazdzinski wrote:
> Maybe the tube is out of bias, to much screen voltage,
> or some resistor has changed value and the LO tube
> voltage is varying around?
> Maybe check things with the DMM?
> Or maybe the bfo is changing, not the LO??
>> -----Original Message-----
>> From: amradio-bounces at mailman.qth.net
>> [mailto:amradio-bounces at mailman.qth.net] On Behalf Of
>> abeck at xplornet.com
>> Sent: Monday, April 10, 2006 9:49 AM
>> To: AMRadio at mailman.qth.net
>> Subject: [AMRadio] HR-10 problem
>> I am running an HR-10 RX in my shack outside and am wondering
>> how to cure an
>> annoying fault. Or, this may be bad design, but I don't
>> remember this from when
>> I was a kid.
>> When i turn up the RF Gain, and end up close to full on it, I
>> get a shift down
>> in frequency of the CW note. So far that I have to retune the
>> BFO to get it
>> The RF Gain is in series with the Cathode of the first RF
>> stage of the RX.
>> perhaps a Zener diode to cure it?
>> And if so, I guess I should measure the voltage someplace and
>> clamp with a
>> zener, but then again, I would be modifying the whole circut.
>> Anyone know how to fix this?
>> Best 73,
>> AMRadio mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/amradio
>> Help: http://mailman.qth.net/mmfaq.html
>> Post: mailto:AMRadio at mailman.qth.net
>> AMfone Website: http://www.amfone.net
>> AM List Admin: Brian Sherrod/w5ami, Paul Courson/wa3vjb
> AMRadio mailing list
> Home: http://mailman.qth.net/mailman/listinfo/amradio
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:AMRadio at mailman.qth.net
> AMfone Website: http://www.amfone.net
> AM List Admin: Brian Sherrod/w5ami, Paul Courson/wa3vjb
More information about the AMRadio mailing list
This page last updated 21 Oct 2017.