|[AMRadio] Ranger... good news, bad news|
w4bws at comcast.net
Mon Nov 6 15:16:30 EST 2006
You can make a plug from an old octal tube base by removing or cutting off
the pins and soldering a wire into the pin. Then plug the wire/pin into the
back panel socket. You can make a dam from an old cap plug or wax paper and
fill the plug with casting plastic, epoxy or RTV.
Plugs are available on the e place occasionally or on one of the several BA
or equip lists.
----- Original Message -----
From: "Jack Schmidling" <jack at schmidling.com>
To: <ne1s at neandertech.com>; "Discussion of AM Radio in the Amateur Service"
<amradio at mailman.qth.net>
Sent: Sunday, November 05, 2006 10:48 PM
Subject: Re: [AMRadio] Ranger... good news, bad news
> Larry Szendrei wrote:
> > Modify the accessory plug as follows (or make a new one if you can find
> > a spare): remove the jumper between pins 2&6. External Ip meter (+)
> > terminal goes to pin 4; meter (-) terminal to pin 2. The jumper between
> > pins 3 & 5 stays as-is.
> > Almost took as long to describe it as it takes to do it...
> Love it. Now the problem is, I have no plug and made separate jumper
> wires that won't lend themselves to tinkering.
> Does any one have a plug for the Ranger they can part with?
> PHOTO OF THE WEEK: http://schmidling.com/pow.htm
> Astronomy, Beer, Cheese, Fiber,Gems, Sausage,Silver http://schmidling.com
> AMRadio mailing list
> List Home: http://mailman.qth.net/mailman/listinfo/amradio
> Partner Website: http://www.amfone.net
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:AMRadio at mailman.qth.net
More information about the AMRadio mailing list
This page last updated 18 Oct 2017.