[AMRadio] Transformer Request


David Knepper collinsradio at comcast.net
Wed Aug 8 07:42:59 EDT 2007


Looking for a steel drawn case (as used in the DX-100, etc.) that measures 2 
inches by 3 inches between the two outer mounting holes.  I want to mount 
another transformer inside the case.  Therefore, the transformer is not 
important to me, just the case.  Prefer three holes in each of the two 
flanges or would accept a potted transformer that has threaded studs.

The original transformer was used in the Collins KWS-1 as the high voltage 
rectifier filament transformer.  When I purchased the unit, the transformer 
was missing, unfortunately.  I assume that the transformer was discarded 
after it failed.

Any assistance would be appreciated

Thank you


David Knepper, W3ST/W3CRA
Secretary to the Collins Radio Association
www.collinsra.com
Publisher of the Collins Journal
Join the CRA - the world's largest Collins group 



More information about the AMRadio mailing list

This page last updated 17 Oct 2017.