[AMRadio] Home-brewing construction considerations


Phil LaMarche plamarc1 at tampabay.rr.com
Fri Jan 18 17:15:41 EST 2008


AND Bret, how did you solve this problem.  I have basic overload with 500
watts where the lights flicker and the TV audio jerks back and forth.  No
TVI.  Ideas?  The HD TV is going though a receiver for SS.

Phil 


Philip LaMarche 
LaMarche Enterprises, Inc.
www.instantgourmetspices.com 
www.w9dvm.com 
800-395-7795 pin 02 
727-944-3226 
FAX 727-937-8834 
NASFT 30210 
W9DVM 
  


-----Original Message-----
From: amradio-bounces at mailman.qth.net
[mailto:amradio-bounces at mailman.qth.net] On Behalf Of Brett Gazdzinski
Sent: Friday, January 18, 2008 5:04 PM
To: ne1s at neandertech.com; Discussion of AM Radio in the Amateur Service
Subject: Re: [AMRadio] Home-brewing construction considerations

And after having built a few rigs with NO consideration about TVI, I would
not spend a lot of time shielding or worrying about out of band signals, I
never had a problem other than raw rf power getting into things.

If it chews up the phone, audio equipment, and 99% of TV interferance, its
just RF overload.

Funny, I can tune the FM radio in the kitchen by changing my TX frequency on
40 meters. The dipole is 30 feet above the radio which has a long wip
antenna on it....

I never had a situation where harmonics or some vhf/uhf stuff from the
transmitters was a problem.



Brett
N2DTS

______________________________________________________________
Our Main Website: http://www.amfone.net
AMRadio mailing list
List Rules (must read!): http://w5ami.net/amradiofaq.html List Home:
http://mailman.qth.net/mailman/listinfo/amradio
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:AMRadio at mailman.qth.net
To unsubscribe, send an email to amradio-request at mailman.qth.net with the
word unsubscribe in the message body.



More information about the AMRadio mailing list

This page last updated 11 Dec 2017.