[AMRadio] Low Power AM?

Bob Macklin macklinbob at msn.com
Sun Nov 23 15:24:56 EST 2008

Can't you just run at reduced input by reducing the loading? Then run the
tube(s) at the CCS rating. The power transformer should take that.

----- Original Message ----- 
From: "rbethman" <rbethman at comcast.net>
To: "Discussion of AM Radio in the Amateur Service"
<amradio at mailman.qth.net>
Sent: Sunday, November 23, 2008 12:14 PM
Subject: Re: [AMRadio] Low Power AM?

> George,
> Good question!  There is NO mention of RTTY operation ANYWHERE in the
> Apache Manual.
> I'm also not sure how you can safely reduce the power out put following
> the tuning procedures, WITHOUT doing some damage to some components.
> It does just fine on AM and CW.  Mixed results on SSB with the SB-10.
> Bob - N0DGN
> George Brand wrote:
> > speaking of the DX series, at reduced power whats the max key down time
> > with rtty on these or other rigs like the DX-100 or Apaches??
> >
> > George WA8SCO
> >
> -- 
> Bob - NØDGN
> ______________________________________________________________
> Our Main Website: http://www.amfone.net
> AMRadio mailing list
> Searchable Archives: http://www.mail-archive.com/amradio@mailman.qth.net/
> List Rules (must read!): http://w5ami.net/amradiofaq.html
> List Home: http://mailman.qth.net/mailman/listinfo/amradio
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:AMRadio at mailman.qth.net
> To unsubscribe, send an email to amradio-request at mailman.qth.net with
> the word unsubscribe in the message body.

More information about the AMRadio mailing list

This page last updated 20 Feb 2018.