[AMRadio] Muting the R390 on transmit


John King k5pgw at yahoo.com
Wed Dec 2 15:15:05 EST 2009


Thanks Larry. I have switched the break in to "ON" and had no mute. I have 12.95 vac at terminal 9 on the terminal board on the rear of the rcvr with the break in switch on and 1.68 vac at terminal 9 when the switch is off. 73, John, K5PGW



----- Original Message ----
From: Larry Szendrei <ne1s at securespeed.us>
To: Discussion of AM Radio in the Amateur Service <amradio at mailman.qth.net>
Sent: Wed, December 2, 2009 1:43:22 PM
Subject: Re: [AMRadio] Muting the R390 on transmit


> Thanks for the reply, Grant. My R 390 doesn't mute when terminal 9 is
> grounded. I have connected an alligator clip lead to terminal 9 and then
> connected the other end of the clip lead to terminal 16 which is ground
> and there is no effect. I can't figure out why there is no effect when
> terminal 9 is grounded. What do you think, Grant? I do not have a manual
> or schematic for the R390. 73, John, K5PGW
>

You didn't mention whether the Break In switch was "on", which, as Grant
said, must be for it (=grounding the break-in terminal) to mute the
receiver. Or, maybe there is a problem in that circuit in your R390. I
used this function on my R390/URR, and it worked exactly as Grant
described.

73/GL,
-Larry/NE1S

-- 
Pay a visit to my amateur radio web page at:
ne1s.rfburn.org
______________________________________________________________
Our Main Website: http://www.amfone.net
AMRadio mailing list
Searchable Archives: http://www.mail-archive.com/amradio@mailman.qth.net/
List Rules (must read!): http://w5ami.net/amradiofaq.html
List Home: http://mailman.qth.net/mailman/listinfo/amradio
Post: AMRadio at mailman.qth.net
To unsubscribe, send an email to amradio-request at mailman.qth.net with
the word unsubscribe in the message body.

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html



      


More information about the AMRadio mailing list

This page last updated 11 Dec 2017.