[AMRadio] Hot microphone


Harold Smith w4pqw at cox.net
Sun Aug 1 13:17:44 EDT 2010


Pin 2 is usually used for push-to-talk.  that means that  they apply 124VDC 
to the top of transmit relay,bottom of relay winding goes to mic connector 
pin 2 ,,when you press the mic transmit button,pin 2 goes to ground ,closing 
the relay and going into transmit mode..I think this is a normal 
siyuation..W4PQW
----- Original Message ----- 
From: "Geoff Edmonson" <w5omr at att.net>
To: "Discussion of AM Radio in the Amateur Service" 
<amradio at mailman.qth.net>
Sent: Sunday, August 01, 2010 11:36 AM
Subject: Re: [AMRadio] Hot microphone


>  On 08/01/2010 11:11 AM, Mark & Paula wrote:
>> Collins 32V1 I'm reading 124 VDC on mic connection pin 2  ? Any ideas 
>> would be helpful.
>> ______________________________________________________________
>
> AC plug properly polarized?
>
> ______________________________________________________________
> Our Main Website: http://www.amfone.net
> AMRadio mailing list
> Searchable Archives: http://www.mail-archive.com/amradio@mailman.qth.net/
> List Rules (must read!): http://w5ami.net/amradiofaq.html
> List Home: http://mailman.qth.net/mailman/listinfo/amradio
> Post: AMRadio at mailman.qth.net
> To unsubscribe, send an email to amradio-request at mailman.qth.net with
> the word unsubscribe in the message body.
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html 



More information about the AMRadio mailing list

This page last updated 19 Oct 2017.