[AMRadio] Ceramic feedline spacers


Bill McCourt - WF1L wemccourt at yahoo.com
Sun Dec 18 20:12:00 EST 2011


I would go with your initial thought.  Bending your feedline wire will work harden it to where it will get brittle and be subject to breakage.

Bill - WF1L

--- On Sun, 12/18/11, AirRadio <AirRadio at dsl.pipex.com> wrote:

From: AirRadio <AirRadio at dsl.pipex.com>
Subject: [AMRadio] Ceramic feedline spacers
To: "Discussion of AM Radio in the Amateur Service" <amradio at mailman.qth.net>
Date: Sunday, December 18, 2011, 12:00 PM

I have a bunch of 2" (hole spacing) ceramic feedline spacers, they have a hole in each end with a groove running around the outside, now here's the question,( and I am only asking this as after looking for most of the evening here I cannot find the answer anywhere) Does the feedline wire go in the hole or on the outside and how to fix the wire to the spacer, I would assume the feedline wire goes in the hole and a wire twist holds it there, however, some say the feedline goes on the outside with the wire twist from the inside.  
73 Max
______________________________________________________________
Our Main Website: http://www.amfone.net
AMRadio mailing list
Searchable Archives: http://www.mail-archive.com/amradio@mailman.qth.net/
List Rules (must read!): http://w5ami.net/amradiofaq.html
List Home: http://mailman.qth.net/mailman/listinfo/amradio
Post: AMRadio at mailman.qth.net
To unsubscribe, send an email to amradio-request at mailman.qth.net with
the word unsubscribe in the message body.

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html


More information about the AMRadio mailing list

This page last updated 17 Nov 2017.