|[AMRadio] Speech processing technologies and methods?|
FRANK HUGHES hughes
frsahu0003 at embarqmail.com
Thu Dec 19 07:27:35 EST 2013
Thanks for the tips!
I will look for a D-104, 32V-2 currently using a mic labeled "General Electric",
but it has a SHURE element, suspect it is just a private label 444D.
The amps I have are old Collins, won't do 160M, not suitable for AM anyway.
So I hope to use the new homebrew amp for 75 and 160 AM.
The new amp is not finished yet.
Most of the metal bashing is done, now working on the control circuits.
It is a 3CX3000A7,based on the work of W2DTC.
----- Original Message -----
From: "Rob Atkinson" <ranchorobbo at gmail.com>
To: "FRANK HUGHES hughes" <frsahu0003 at embarqmail.com>
Cc: "Discussion of AM Radio in the Amateur Service" <amradio at mailman.qth.net>
Sent: Thursday, December 19, 2013 6:51:48 AM
Subject: Re: [AMRadio] Speech processing technologies and methods?
For a 32V your best speech processor is probably a D104 with a good
crystal element. The 32V mod iron isn't going to handle processing
very well and may crap out. I'd run that rig with just a D104 and let
it go at that.
You have to make sure you are running something that can handle the
compression and peak limiting. Broadcast iron can handle it.
Vintage ham rigs stock cannot. The newer solid state rigs like the
K7DYY products probably can.
What is the amp for? If you use the 32V to drive it, it is either
going to be over driven or a hell of an amp. Unless you can reduce
its output I would leave it alone and look for a Ranger to use as an
exciter, or forget the amp and work on a higher power plate modulated
On Thu, Dec 19, 2013 at 5:26 AM, FRANK HUGHES
hughes <frsahu0003 at embarqmail.com> wrote:
> I would like to learn about the speech processor options/techniques to improve what I am presenting the 32V-2 input with.
> Should I start by asking Ray @ ER if he has any back-issues addressing the subject?
> On 3885 I hear many folks discussing their signal processing methods, and can see that it would be fun to learn more about it.
> But first, I have to finish my first attempt at a homebrew amp, then on to new technical horizons.
> Our Main Website: http://www.amfone.net
> AMRadio mailing list
> Archives: http://mailman.qth.net/pipermail/amradio/
> List Rules (must read!): http://w5ami.net/amradiofaq.html
> List Home: http://mailman.qth.net/mailman/listinfo/amradio
> Post: AMRadio at mailman.qth.net
> To unsubscribe, send an email to amradio-request at mailman.qth.net with
> the word unsubscribe in the message body.
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
More information about the AMRadio mailing list
This page last updated 23 Nov 2017.