|[AMRadio] [Hallicrafters] sources for alignment tools|
hallicrafterssr2000 at k9axn.com
Tue Mar 31 10:52:07 EDT 2015
My email folders are all screwed up and your right about the right tool. I
am certain that I read somewhere someone has a very rigid alignment tool.
Everything that I have is junk plastic. Point me.
Kindest regards Jim K9AXN
From: manualman at juno.com
Sent: Tuesday, March 31, 2015 1:47 AM
To: hammarlund at mailman.qth.net
Cc: amradio at mailman.qth.net ; hallicrafters at mailman.qth.net
Subject: Re: [Hallicrafters] [AMRadio] sources for alignment tools
It's much easier to split a soft powered slug that's very hard to turn or
jammed in a core with an allen wrench. Get a good quality set of
alignment tools that's designed for the job.
On Mon, 30 Mar 2015 20:36:07 -0500 <james.liles at comcast.net> writes:
> Hi Bob,
> I use a 2.5mm allan wrench to start them then the plastic. Helps to
> from splitting the slug.
> Kindest regards Jim K9AXN
> -----Original Message-----
> From: Robert Sauvan
> Sent: Monday, March 30, 2015 6:43 PM
> To: Hammarlund Mail List ; Hallicrafters ; AM Radio
> Subject: [AMRadio] sources for alignment tools
> Hi all,
> I am in need of some new alignment tools. In particular, the hex
> piece to tune coil slugs. I have been searching, but only find
> looking plastic ones like I have presently. I would like to find
> something that is a bit harder and stronger than the ones I am
> The ones I have, worked fine for a bit. But, when you run across a
> slug to turn, they sorta just slip and get rounded off due to the
> plastic. What is everyone using and where are you getting them?
Hallicrafters mailing list
Post: mailto:Hallicrafters at mailman.qth.net
List Administrator: Duane Fischer, W8DBF
** For Assistance: dfischer at usol.com **
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
More information about the AMRadio mailing list
This page last updated 18 Feb 2018.