[AMRadio] Any WRL Globe Scout experts out there?

Lee Bahr L at w0vt.us
Thu Jan 4 21:01:26 EST 2018


The screen voltage also started out at 500 volts and you should only 
have 18 volts on the screen of the 6SJ7 tube which is pin 6. The plate 
of the 6SJ7 tube is pin 8.

Lee, w0vt

On 1/4/2018 7:47 PM, Lee Bahr wrote:
> Charlie,
> All I can tell you is I have replaced the pentacoupler with discreet 
> parts for the same reason as you describe.  I used the same values as 
> in the pentacoupler and had no problem.  The resistor is not going to 
> lower voltage very much as it draws very little current.  That would 
> not be true if the circuit drew a lot of current.  The speech amp 
> tubes have around 55 volts on their plates.  Their source voltage 
> started out at around 500 volts. Just put in the discreet parts and if 
> you are concerned, check to see if you have around 55 volts on the 
> plates of the audio pre-amp tubes.
> Lee, w0vt
> On 1/4/2018 7:23 PM, CL in NC via AMRadio wrote:
>> The Globe Scout I am working on has an issue with the PC91 
>> Pentacoupler.  The main thing I am wondering is that, internally, the 
>> PC91 has a 4.7 meg resistor feeding B+ to the screen of the pentode 
>> section of the 6U8A. I do no recall ever seeing a screen resistor 
>> that high in any audio amp circuit.  In this PC91, that particular 
>> resistor is reading 8 Megs, the other two are high in value, but not 
>> that high, only about15% off. Are there any mods out there for 
>> changing the mic amp circuit in this TX?  Does it really need a 
>> change or just pull the PC91 out and  put the right discrete 
>> components in the amp circuit as shown in the schematic of the PC91, 
>> and leave that section stock?
>> Charlie, W4MEC in NC
>> ______________________________________________________________
>> Our Main Website: http://www.amfone.net
>> AMRadio mailing list
>> Archives: http://mailman.qth.net/pipermail/amradio/
>> List Rules (must read!): http://w5ami.net/amradiofaq.html
>> List Home: http://mailman.qth.net/mailman/listinfo/amradio
>> Post: AMRadio at mailman.qth.net
>> To unsubscribe, send an email to amradio-request at mailman.qth.net with
>> the word unsubscribe in the message body.
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to l at w0vt.us

This email has been checked for viruses by Avast antivirus software.

More information about the AMRadio mailing list

This page last updated 22 Feb 2018.